PLUS XD COATING OVER FOAM PLASTIC INSULATION SYSTEM MEETS AC 377 APPENDIX X REQUIREMENTS AT LOWEST WET MIL THICKNESS No-Burn® Plus XD is now approved over Demilec’s Sealection® 500 at the lowest tested wet mil thickness, surpassing previous results. The test was performed in accordance with AC 377 Appendix X. Plus XD, used in lieu of a prescribed ignition barrier, applied at a thickness of 6 mils wet (4 mils dry). At this thickness, No-Burn Plus XD will cover approximately 267 sq. ft. per gallon. "Offering our intumescent coating to Demilec installers at this thickness in the short-term means competitive bids and more awards” said Bill Kish, CEO of No-Burn, Inc. “Long-term, No-Burn, Inc. and Demilec continue to thrive as both the coatings and spray polyurethane foam markets experience continued growth. Our partnership brings building owners, suppliers and contractors domestically manufactured products at valued rates.” No-Burn® Plus XD is a low VOC intumescent coating manufactured in the USA; meeting both International Building Code (IBC) and International Residential Code (IRC) specific requirements for spray applied foam plastic insulation systems, while contributing to LEED regional material points and complying with the ARRA Buy American provision, Plus XD is available directly through Demilec USA and Service Partners nationwide. Technical questions about Plus XD should be directed to the manufacturer, No-Burn, Inc. Estimating and technical support are provided by No-Burn, Inc. No-Burn® applicators are invited to take the comprehensive online training. Email info@noburn.com for direct customer support and training access.
